KAD/ADC/114 16 channel Full-bridge ADC

Download Data Sheet
  • Overview
  • Specifications
  • Downloads
  • Featured Products
  • Request a Quote
  • Product Support

The KAD/ADC/114 is used to condition and digitize up to 16 differential-ended analog channels. At the heart of the KAD/ADC/114 is a hard-wired state machine that oversamples all channels at a rate between 48 ksps and 96 ksps and digitally filters any noise above the user-programmable cutoff frequency.

This is achieved using cascaded, half-band, Finite-Impulse-Response (FIR) filters followed by an 8th order Butterworth Infinite-Impulse-Response (IIR) filter with a default cutoff point set at one-quarter of the sampling frequency (fc = fs / 4). All signals are sampled simultaneously. Thus, when several channels are sampled at different sampling rates, at the start of an acquisition cycle all channels are aligned.

Excitation on the KAD/ADC/114 is programmable using four D/A converters, each of which is connected to two pairs of drivers. If more than eight excitations are required, each excitation output can be connected to two bridges.

The KAD/ADC/114 is available with three different input ranges (±10V, ±1V, and ±100mV). The input range must be specified when ordering.

Features

  • 16 full or ½bridge, potentiometer or differential ended input channels
  • Ordering input range (±100mV, ±1V,±10V)
  • High accuracy (0.01% FSR typical for /1V, /10V variant, 0.02% FSR for /100mV variant)
  • Programmable voltage excitation per two channels and balance adjust per channel
  • Shorts only affect channels sharing excitation
  • 16-bit simultaneous sampling on each channel
  • Up to 12 k samples per second per channel
  • Up to 3 kHz Bandwidth (AAAF filter)

Applications

  • Analog signal Acquisition Differential Ended
  • Full Bridge
  • Half Bridge
  • Potentiometer
CAPTCHA
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.

KAD/ADC/114 16 channel Full-bridge ADC

Download Data Sheet